How to Measure for Reversible Cushions

   


Reversible Pew Cushions Measurement

Please provide the following information when requesting a quotation for Pew Form Cushions. All measurements should be in inches(not feet) to the nearest 1/8".

Length:
 To determine the length, using a steel tape measure, measure along the back of the pew seat from inside end to inside end.

If the pew has a center divider, measure each section separately from the pew end to the divider. Record the length to the nearest one eighth inch.

Width:
 1. When there is a small radius at the front edge, measure from the back corner of the seat to the start of the  radius at the front edge.
 2. When there is a large radius at the front edge, measure from the back corner of the seat to half way down the  radius at the front edge.
 3. Customer advises their preference.

Please send photographs via email if possible of the following to confirm measurements and any possible problems, odd ends or corners.

Styles: 
 #1 - 1 ½" thick high density foam padding, plain cushion, no welting on edges.
 #2 - 2" thick high-density foam padding, plain cushion, no welting on edges.
 #3 - 2" thick high-density foam padding with welted edges.

All Reversible Cushions have full-length zippers on back edge.
 Tufted buttons are optional.
 Fitted ends, Rounded corners, and Mitered cuts are also available.

Atwood-Hamlin Mfg. Co. Inc.
P.O. Box 578
Richmond, IL 60071
Phone (800)545-8964
Fax (815)678-2130
Info@Atwood-Hamlin.com